Operating instructions

OPERATING INSTRUCTIONS

9395

9-21-04-2

CAUTION! Periodic observation must be made of the transmission oil

temperature indicator when planing with high flow hydraulic

systems.

Depending on the ambient temperature and the duty cycle of

the machine, hydraulic oil may overheat.

If indicator comes on, shut off the cold planer and allow the

skid-steer to idle until the temperature falls below 160° Fahren-

heit.

If the system continues running hot it may be necessary to

clean any debris from the oil cooler and radiator. Check engine

air filter and also the hydraulic oil level.

Continuous or excessive overheating may cause machine

damage.

SPECIAL APPLICATIONS

LARGE AREA

BRADCO'S independent depth control design allows for continuous mill-

ing. Instead of planing pass 1, 3, 5 and then going back and resetting the planer

for passes 2 and 4, the BRADCO planer allows for individual depth control from the

operator's seat to enhance performance and continually mill large areas.

MILLING AROUND MANHOLES

For best visibility when

milling around manholes it is

recommended that the planer be

shifted to the right. The planer is not

designed to mill around tight cor-

ners, therefore it is recommended

that four to six passes be made on

each side of the manhole. NOTE:

The more passes the less amount

of manual clean-up required.

1st PASS

2nd PASS

3rd PASS

1st PASS

2nd PASS

3rd PASS

1st PASS

4th PASS

MANUAL

CLEAN-UP

AREA

MANHOLE

OR BASIN