Operating instructions

INSTALLATION INSTRUCTIONS

9834

9-23-04

8. Following all standard safety practices, start the skid-steer and run all

cylinders through their full cycle to purge any air from the system. Check that

all controls function in accordance with the operating control decal.

9. If your planer is equipped with an optional water kit, install the female coupler

supplied to your water line coming from the water tank on the skid-steer.

Connect the female coupler to the male coupler on the planer water kit.

Your planer is now installed and ready for operation.

DISCONNECT INSTRUCTIONS

1. Center the planer on the sideshift frame.

2. Adjust depth and tilt setting to "0".

3. Set cold planer on a firm level surface.

4. Following Safety Shut Down Procedures; stop the engine and set the parking

brake. Relieve any pressure in the hydraulic lines.

5. Disconnect the power and return hoses from the auxiliary hydraulics.

6. Disconnect the electrical wire harness from the auxiliary electrical connector

or the BRADCO control handle and after turning the ball valve to the shut off

position disconnect the water line at the couplers.

7. Following all standard safety practices and the instructions for disconnecting

an attachment in your skid-steer operator's manual, disconnect the planer

from your skid-steer allowing the mounting bracket to lower toward the

ground as the skid-steer is disengaged.

8. Connect the hydraulic couplers on the attachment together to prevent con-

taminants from entering the hydraulic system.