Operating instructions

INSTALLATION INSTRUCTIONS

9833

11-4-05-2

GENERAL INFORMATION

The following instructions will help you to mount your planer onto your

skid-steer loader. The planer uses the quick-attach system for ease of installa-

tion. Therefore, if you know how to attach your loader bucket, attaching the cold

planer should prove no problem.

Remember to read all safety warnings, decals and operating instructions

before operating the attachment. If there is any portion of this manual that you do

not understand, contact your dealer.

WARNING! THE 16", 18", 24", 30" AND 40" PLANERS ARE DESIGNED FOR

USE ON HIGH FLOW HYDRAULIC SYSTEMS.

DO NOT ATTACH OR OPERATE ANY ATTACHMENT THAT EX-

CEEDS THE RECOMMENDED LIFTING CAPACITY OF YOUR SKID-

STEER.

INSTALLATION INSTRUCTIONS

1. Remove the shipping banding from around the planer and skid.

2. Remove any attachments from the front of the loader.

3. Following all standard safety practices and the instructions for installing an

attachment in your skid-steer operator's manual, install the planer onto

your skid-steer.

NOTE: It is important to make sure the locking mechanism on your quick attach

is engaged, therefore locking the attachment onto the skid-steer.

4. Lower the unit to the ground and remove the key.

5. Relieve any pressure from the auxiliary hydraulic system and after making

sure that there is not any foreign matter on the hydraulic couplers, connect the

power and return couplers to the high flow auxiliary hydraulic system of your

skid-steer loader.

6. Connect the case drain coupler to the case drain on your skid-steer loader.

Route the hoses in such a fashion as to avoid pinching or chafing.

CAUTION! BE SURE CASE DRAIN COUPLER IS COMPLETELY ENGAGED.

IMMEDIATE HYDRAULIC MOTOR SEAL FAILURE AND PLAN-

ETARY DAMAGE WILL OCCUR IF CASE DRAIN IS NOT SUC-

CESSFULLY CONNECTED.

7. Connect the electrical wire harness from the cold planer to the auxiliary

electrical connector on the front of the skid-steer (if so equipped). If your skid-

steer is not equipped with an electrical connector and you are using the

BRADCO control handle, connect the wiring harness to the control handle and

place the control handle inside of the skid-steer operator's station.

WARNING! Do not operate the cold planer from outside of the skid-steer

operator's station.