C330X Operation-Manual GB

Table Of Contents

-23

Connections

Connecting to a Computer

Before connecting, ensure the power cord of the projector from the AC outlet is unplugged,

and that the devices to be connected are turned off. After making all connections, turn on the

projector and then the other devices. When connecting a computer, ensure that it is the last

device to be turned on after all the connections are made.

Ensure the operation manuals of the devices to be connected have been read before making connections.

When connecting with the RGB cable

(Connecting to COMPUTER/COMPONENT 1 or 2: The illustration shown below is for the former.)

To audio output terminal

To RGB output terminal

* ø3.5 mm stereo or mono audio cable

(commercially available or available as Sharp service part QCNWGA038WJPZ)

To COMPUTER/

COMPONENT 1

input terminal

Computer

To AUDIO input terminal

RGB cable

When using the ø3.5 mm mono audio cable, the volume level will be half of when using the ø3.5 mm stereo audio cable.

Note

• See page 63 “Computer Compatibility Chart” for a list of computer signals compatible with the projector.

Use with computer signals other than those listed may cause some of the functions to not work.

• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest

Macintosh Dealer.

• Depending on the computer you are using, an image may not be projected unless the computer’s

external output port is switched on. (e.g. Press “Fn” and “F5” keys simultaneously when using a

SHARP notebook computer). Refer to the specific instructions in your computer’s operation manual to

enable your computer’s external output port.

RGB cable

Supplied

accessory