Operation Manual
Table Of Contents
- Introduction
- Easy Start
- Setup
- Connections
- Basic Operation
- Useful Features
- Operating with the Remote Control
- Menu Items
- Using the Menu Screen
- Picture Adjustment (“Picture” Menu)
- Audio Adjustment (“Audio” Menu)
- Signal Adjustment (“SIG” Menu)
- Screen Adjustment (“SCR” Menu)
- Helpful Functions Set during Installation (“PRJ” menu)
- Setting Up the Projector Network Environment (“Net.” Menu)
- Viewing Stereoscopic 3D Images
- Appendix
77
Appendix
Attaching the Ceiling-mount Rotating Module
(AN-SV100T)
1
Press STANDBY/ON on the
projector or STANDBY on the
remote control to put the
projector into Standby mode.
Then disconnect the power cord.
2
Turn over the projector and place
it upside down on a fl at surface.
Remove the connector cover.
3
Place the ceiling-mount rotating
module on the bottom of the
projector so that it is aligned
with the module installation
holes on the projector. (Make
sure the three position-setting
pins on the module are inserted
into the position-setting holes on
the projector.)
4
Using the supplied bolts, attach
the ceiling-mount rotating
module to the projector.
First, lightly screw all four bolts
and then tighten them fi rmly.
1
2
3
4