Specifications
SmartPanel Projector Driver Application Note
Sharp XG-P20XU
© 2002 SP Controls Inc. 601 Minnesota Suite 115 San Francisco, CA 94107
help@spcontrols.com
LENS SELECT is a function that accesses a menu controlling FOCUS, ZOOM, LENS SHIFT,
KEYSTONE, and DIGITAL SHIFT. Once this menu is called, use the hidden function ADJUST
commands to change settings (while still holding down the ON key). Continue pressing LENS SELECT
to toggle through the available LENS SELECT functions. Pressing ENTER while the LENS SELECT
menu is active will display a test pattern, and pressing UNDO while the LENS SELECT menu is active will
restore the default setting.
AUTO SYNC can only be used when RGB input is detected.
Hidden functions are accessed by pressing the indicated key while the holding the On key down.
The hidden functions available for the Sharp with this Driver are as follows:
MENU
ADJUST LEFT
ADJUST RIGHT
ADJUST UP
ADJUST DOWN
ENTER
BLACK SCREEN
LENS SELECT
AUTO SYNC
LENS ZOOM UP
LENS ZOOM DOWN
RESIZE
FREEZE
GAMMA SETTINGS
ENLARGE
UNDO
D. Relays
The following table specifies the factory preset
settings for the low-current relays found on the rear
of the SmartPanel. The Configuration Utility can
be used to customize these settings your installation.
Relay 1 ON Maintained
Relay 2 ON Momentary
Relay 3 OFF Momentary
Selection Momentary; not Binary
E. Other Presets
The following table specifies other default factory settings for this Driver that affect is control of the
Projector.
Power Status Feedback Method Current Sensor
Control Wiring Option Wired Remote or IR Emitter (see note 2)
NOTE: Due to an interoperability issue, Power Polling for this projector is not available. If power feedback
is required, we recommend using a third party power current sensor. If the projector's automatic shutoff
timers are disabled, the SmartPanel will reliably remain in sync with the projector unless the projector is
powered on or off manually.
Control for the Sharp with this Driver is via RS-232 and Wired Remote. An IR Emitter can alternately be
used.
NOTE: If the Panel is wired to the Projector’s Wired Remote port, the Wired Remote port must be
manually switched to IR on the projector.
RELAYS
PWR
ON
MAINT.
PWR
ON
MOM.
PWR
OFF
MOM.
1A
1B
3A
3B
2A
2B
4A
4B
6A
6B
5A
5B
7A
7B
SELECTION
(EXT. SWITCHER CTRL)
4321
500mA MAX. CURRENT