User`s manual

Extron • System 4
xixi
xixi
xi Switcher Series • User’s Manual • P/N 68-409-02 Rev. C
Configuration and ConnectionsSharp Installation
Page 9
6. Plug the 15-pin HD connector of the Projector Communications Extension cable
into the PJ Comm port on the System 4xi. The other end of the cable has a 9-pin
female connector. Plug this end into the 9-pin male D connector on the
Universal Comm adapter.
______ Secure all of the connector screws.
7. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) BNC-4 or
5 cable onto the System 4xi output. If the projector end of the BNC cable has
BNC connectors, set the input type selector switch (see illustration below) to
“BNC” and attach the BNC connectors. If the projector end of the BNC cable
has a 15-pin HD connector, set the input type selector switch (see illustration
below) to “15-pin” and attach the 15-pin connector to the Computer RGB Input 1
port of the projector.
________ Important note! When connecting the System 4 xi BNC output to either the
projector’s BNC or 15-pin input (but not both simultaneously), set the projector’s
input type selector switch to the appropriate “BNC” or “15-pin” setting.
System 4
xixi
xixi
xi Series – Sharp NV6 Projector Connections
Use the illustration below as a guide when connecting the System 4xi to a Sharp
NV6 projector. Refer to Sharp documentation to continue the installation.
____________ In a rack mount, do NOT allow the weight of the cables to be supported by the
System 4 xi . See page 2-5 for cabling guidelines.
9-pin female
9-pin male
RGBHV 5 BNC
15-Pin
Male
Universal
CommAdapter
26-467-01
OUTPUT
PJ COMM
RS 232
AUDIO AUDIO AUDIO AUDIO AUDIO
H/HV
R/C G/Y BR/C G/Y B
V
INPUT 4
H/HV V
R/C G/Y B
INPUT 3
H/HV V
R/C G/Y B
INPUT 2
H/HV V
R/C G/Y B
INPUT 1
H/HV V
CC cable
input type
selector switch
refer to the above note
when connecting the
BNC output from the
System 4 xi
Sharp RS-232C
cable