User`s manual

Extron • System 4
xixi
xixi
xi Switcher Series • User’s Manual • P/N 68-409-02 Rev. C
Sharp Installation Configuration and Connections
Page 6
(Note: Information depends on
S
y
stem 4 setu
p
.
)
(See note.)
(See note.)
(See note.)
(See note.)
[System 4 model and software
version displayed here]
Connecting System 4
xixi
xixi
xi to Sharp XG-E1200U LCD Projector
__________ Important note! Because the Sharp XG-E1200U projector’s Computer Input port
requires an RGB signal between VGA and XGA rates, you will not be able to
install System 4LQxi with this projector.
The Main Controller Board configuration for the Sharp XG-E1200U is the same
as the standard Sharp XG-series configuration as shown below.
1. Use the Front Panel to display the Information Menu to verify that the System 4xi
is already set up for the Sharp projector. Apply power to the System 4xi and do
the following:
a. Press
to display the MENU SELECT on the LCD screen.
b. Press or to step to Menu 8.
c. Press to select this menu.
d. Press or to display the configuration. The example to the left is general,
yours will show the System 4xi model name, the software version and the
following information:
PRJ = SHARP
PRJ BAUD = n/a
UNIT No. = 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2. Go to the procedure on page 2-3 of the System 4 Series User’s Manual to
remove the System 4xi cover and then go to page 2-4 to set up the Main
Controller board. Return to Step 3 (below) when the configuration is correct.
Config Projector SW1: 1-2-3-4 SW2 SW3 SW4 SW5 SW6 Prj Cable Comm
as Adapter
Sharp XG-E1200U off-on-off-on 0 0 3 F 0 J15 26-426-01
3. Double-check your work and be sure the System 4xi cover is on securely.
4. Install the System 4xi in its place of operation (i.e. rack), but not powered on.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
5. The Sharp COM Adapter has one 9-pin male connector that accommodates the
Comm Extension cable. It also has one miniphone plug and one power plug.
Insert the miniphone plug into the Wired Remote input jack of the projector and
insert the power plug into the DC5V Output port of the projector.
}
SW1
ON
SW2
SW4
SW3
SW5
J15
3
4
1
2