User`s manual

Extron • System 4
xixi
xixi
xi Switcher Series • User’s Manual • P/N 68-409-02 Rev. C
Configuration and ConnectionsSharp Installation
Page 5
5. The Sharp COM Adapter has one 9-pin male connector that accommodates the
Comm Extension cable. It also has one miniphone plug and one power plug.
Insert the miniphone plug into the Wired Remote input jack of the projector and
insert the power plug into the Aux power port of the projector.
6. Plug the 15-pin HD connector of the Projector Communications Extension cable
(shown as CC 50') into the PJ Comm port on the System 4xi. The other end has
a 9-pin female connector. Plug this into the other 9-pin male D connector on the
Sharp COM adapter.
______ Secure all of the connector screws.
7. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) SY-VGA
cable onto the System 4xi output and those on the other end into the RGB 2
(Computer RGB Input) port of the projector.
System 4
xixi
xixi
xi - Sharp XG1000 LCD or E1100 LCD Projector Connections
Use the illustration below as a guide when connecting the System 4xi to a Sharp
XG1000 or E1100 projector. Refer to Sharp documentation to continue the
installation.
____________ In a rack mount, do NOT allow the weight of the cables to be supported by the
System 4 xi . See page 2-5 for cabling guidelines.
4 or 5 BNC
SY-VGA
Cable
CC 50'
9-Pin
Sharp COM
Adapter
26-426-01
AUDIO VIDEO S-VIDEO
WIRED
REMOTE
DC12V
OUTPUT
MAX CURRENT
200mA
C-SYNC
RGB INPUT
INPUT
1
INPUT
2
OUTPUT
RL
RG B
AUDIO ANALOG RGB15.75kHz/15.625kHz
-
+
Sharp XG-1000 or E1100 Projector
Filter
ON
OFF
ANALOG DIGITAL
COMPUTER RGB INPUT
COMPUTER RGB OUTPUT
red
cable
15-Pin