Instruction manual

When the printed text is getting dark or faint, paper dust may be stuck to the print head, sensor and/or roller.

Clean them as follows:

Caution:

• Never touch the print head with a tool or anything hard

as it may damage the head.

• The paper cutter is mounted on the printer cover. Be

careful not to cut yourself.

1. Turn the mode switch to the OFF position.

2. Remove the printer cover.

3. Lift up the print roller release lever to unlock and open the

print roller arm.

4. Remove the paper roll referring to the “Removing the

paper roll” section.

5. Clean the print head with a cotton swab or soft rag

moistened with ethyl alcohol or isopropyl alcohol. Clean

the roller and the sensor in the same manner.

6. Reset the paper roll correctly by following the steps in

“Installing the paper roll”.

The drawer in the register is detachable. After closing your business for the

day, remove the drawer. To detach the drawer, pull it forward fully, and

remove it by lifting it up. The 5-denomination coin case is detachable.

The drawer automatically opens. However, when a power failure occurs or the

machine becomes out of order, slide the lever located on the bottom of the

machine in the direction of the arrow. (See the figure at the left.)

The drawer will not open if it is locked with the key.

1. On the rear side of the spill-proof cover, adhesive tapes are attached. Remove the top tapes.

2. Lightly place the cover on the keyboard.

3. When you position the cover correctly, press the adhesive tape area to fix the cover.

Spill-proof cover

Adhesive tape

Mounting the Spill-proof Cover

Lever

Opening the Drawer by Hand

Removing the Drawer

Cleaning the Printer (Print Head / Sensor / Roller)

Coin case

Print head

Roller

Sensor