Service manual

XE-A201US
– 16 –
<After pushing "Add Files">
*1 COM Port is selectable between COM1 and 2.
*2 For "Send Type", select "Direct".
*3 Do not select "Extra Setting".
<XE-A201 side>
12) Turn on the AC Power.
13) Open the cabinet.
14) Change the Jumper PIN (SP1) to the front side. (default position)
15) Close the cabinet.
16) Turn on the AC Power.
Master Reset will be performed. If not, power off the XE-A201,
wait 1miniute and turn on the power again.
APPENDIX: RS232C CABLE
The RS-232C cable (QCNWG3190BHZZ) provided together with the
XE-A201 is used to connect the XE-A201 and a PC when using the
customer support tool or performing IPL.
When using the cable, connect the core side of the cable to the XE-
A201 as shown in the figure below.
The accessory RS-232C cable has the following internal
connections:
(Equivalent to a cross cable used in the conventional connection of
ECR-ECR)
SD : TRANSMITTED DATA
RD : RECEIVED DATA
DTR : DATA TERMINAL READY
DSR : DATA SET READY
RTS : REQUEST TO SEND
DCD : DATA CARRIER DETECTOR
CTS : CLEAR TO SEND
PC
XE-A201
RS232C
CABLE
CORE
SD 3 SD
RD
CTS
RD
2
6
8
3
2
6
8
55 SG
RTS
7
DCD
1
DTR 4
DSR
7
1
4
CTS
SG
RTS
DCD
DTR
DSR
9PIN D-SUB 9PIN D-SUB