User manual

Contents
Contents-2 BioRobot EZ1 DSP Workstation User Manual 02/2007
3.2 Internal features of the BioRobot EZ1 DSP 3-5
3.2.1 Worktable 3-6
3.2.2 Pipettor head 3-9
4 Installation Procedures 4-1
4.1 Requirements 4-1
4.2 AC power connection 4-1
4.3 Hardware installation 4-3
5 General Operation 5-1
5.1 Overview 5-1
5.2 Inserting and removing the EZ1 Card 5-2
5.2.1 Inserting the EZ1 Card 5-2
5.2.2 Removing the EZ1 Card 5-3
5.3 Switching the BioRobot EZ1 DSP on and off 5-4
5.3.1 Switching on the BioRobot EZ1 DSP 5-4
5.3.2 Switching off the BioRobot EZ1 DSP 5-5
5.4 Opening and closing the workstation door 5-5
5.4.1 Opening the workstation door 5-6
5.4.2 Closing the workstation door 5-6
5.5 Starting and stopping a protocol run 5-6
5.5.1 Starting a protocol run 5-6
5.5.2 Stopping a protocol run 5-7
5.6 Setting up the worktable 5-8
5.6.1 Removing and replacing the tray 5-9
5.6.2 Loading the reagent cartridges 5-9
5.6.3 Loading the elution tubes, filter-tips, and sample
tubes 5-11
6 Preventive Maintenance 6-1
6.1 Regular maintenance procedure 6-2
6.2 Daily maintenance procedure 6-4