Service manual

VL-WD250U
VL-WD450U
7
4. DISASSEMBLY OF THE SET
Note:
Before removing the cabinet, turn off the power supply, and ascertain that the battery have been removed.
1.
3.
(d)
(d)
(c)
(b)
(b)
1) Remove the screws ((c)XiPSF17P04000)(5 pcs.) and ((b)LX-
HZ0063TAFF)(1 pc.) on the bottom cover to remove the bottom
cover.
2) The screws ((d)XiPSN17P04000)(2 pcs.), ((b)LX-HZ0063TAFF)(1
pc.) and ((e)LX-HZ0063TAFN)(1 pc.) on the front cover, and open
the front cover. Then disconnect the connector of the microphone.
3) Remove the screws ((d)XiPSN17P04000)(3 pcs.) fixing the shoe
angle to remove the shoe angle. Remove the connector of the
zoom microphone which is located in the front, and then slide the
top side cover forward and lift it up to remove it.
4.
5.
1) Remove the screws ((b)LX-HZ0063TAFF)(5 pcs.) to remove
the joint PWB.
2) Disconnect the connector of the operation PWB.
3) Remove the screws ((b)LX-HZ0063TAFF)(3 pcs.) to remove
the operation PWB.
(b)
(b)
(b)
Operation PWB
connector
1) Disconnect the connector of the turn SW.
2) Remove the joint main FPC.
3) Remove the LCD FPCs (2 sheets), and lift up the cabinet B ass'y.
1) Turn the V/F, and then remove the screws ((b)LX-HZ0063TAFF)(7
pcs.) and ((c)XiPSF17P04000)(1 pc.) fixing the battery cover.
Disconnect the connector of the battery terminal on the bottom.
2) Remove the screws ((d)XiPSN17P04000)(4 pcs.) on the top
side and the screw ((d)XiPSN17P04000)(1 pc.) on the side.
2.
(c)
(b)
(b)
(d)
(d)
(d)
(e)
LCD FPC 1, 2
Joint main FPC
Turn SW connector
1) Disconnect the connectors (2 pcs.) of the lens, remove the
screw ((d)XiPSN17P04000)(1 pc.), and lift it up.
2) Disconnect the connector of the V/F, remove the screw ((d)
XiPSN17P04000)(1 pc.), and lift up the V/F unit to remove it.
(d)
(d)