Manual

Attaching
Power switch
Make sure that the Power
switch is set to OFR
Removing
1 Make sure that the Power switch is set
to OFF.
Rotate the monitor section of the
camcorder (,i:), then press the battery
release (:2). Slide the battery pack in
the directien ol the arrow and take it out
(@).
Align the D mark on the side of the
battery pack with the D mark on the
camcorder (_i }, and elide the battery
pack in the directien d the arrow
completely until it locks into place (_).
Batter
Cautions:
• BEFORE REMOVINGTHE BATTERY PACK,
ALWAYS STOP RECORDING OR PLAYBACK
ANDTURNTHE POWER OFF, Removing the
battery pack while shooting or during playback
may damage the tape by causing it to wrap
around the video head drum.
• Remove the battery pack from the camcorder if
you will not use the camcorder for a Io% period
of time.
_,Make sure that the battery pack is firmly
attached during operation. If it is not, the battery
pack may come off or camcorder operation may
fall because of the poor contact pressure.
• To prevent damage to the battery pack when
removing, b_ sure to firm(y hold the battery pack
while pressing the release.
• Use only SHARP model BT-L225 or BT-L445
battery packs with this camcorder. Use of other
batteries may create a risk of fire or explosion.