Service manual

VL-MC500U/K
9
6.
7.
5.
(a)
(a)
(b)
(a)
(d)
(d)
(d)
(d)
(d)
Battery Cover
(d)
(d)
(d)
(f)
(f)
(f)
(d)
(d)
(d)
(d)
(d)
Camera Rear Cabnet
Camera Front Cabnet
Lithium Battery Lid
(d)
(d)
Connect
Connect
FPC
Connect
(d)
(d)
(d)
1) Take out the mechanism in the direction of the arrow.
2) Remove the three floating screws ((a)LX-BZ0251TAFD) and the
one floating screw ((b)LX-BZ0253TAFN).
3) Remove the five screws ((d)XiPSN17P03000) to detach the battery
cover.
1) Detach the lithium battery lid.
2) Turn the tilt section in the direction of the arrow, and remove the five
screws ((d)XiPSN17P03000) and the three screws
((f)XiPSN17P04000) which fix the camera front cabinet. Then
detach the camera front cabinet in the direction of the arrow.
3) Remove the three screws ((d)XiPSN17P03000) fixing the camera
rear cabinet and the one screw ((d)XiPSN17P03000) fixing the
hand strap fitting.
4) Disconnect the microphone wire connector, and detach the camera
rear cabinet in the direction of the arrow.
1) Remove the three screws ((d)XiPSN17P03000) to detach the
angle.
2) Remove the two screws ((d)XiPSN17P03000), the three connec-
tors and the two FPCs, and detach the tilt section in the direction
of the arrow.