Specifications

Installing the Memory Backup
Battery
1
2
3
4
5
Insert the battery pack, or connect the
VIEWCAM to the AC adapter or car battery
adapter, then slide the release and open
the cassette compartment door.
l The cassette holder extends and opens
automatically.
Cassette compartment
door release
Pull out the battery holder using a pointed
object such as the tip of a ballpoint pen.
Battery’ holder
Insert the supplied lithium
battery into the holder with
the + side facing down.
Insert the battery holder back
into its compartment and push it
in completely.
Close the cassette holder gently pressing
the “PUSH” mark.
l The cassette holder retracts automatically.
Wait for the cassette holder to fully retract,
and then close the cassette compartment
door pressing its center until it clicks into
place.
“PUSH” mark
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type CR2025 recommended
by the equipment manufacturer.
B KEEP THIS BATTERY AWAY FROM
CHILDREN. IF SWALLOWED, CONSULT A
PHYSICIAN IMMEDIATELY FOR EMERGENCY
TREATMENT.
Cautions:
l If the lithium battery is installed with polarity
reversed, the backup function will fail.
l Do not short-circuit, recharge, disassemble, or heat
the battery.
l Should the battery leak, wipe the battery
compartment clean, and then insert a new battery.
Notes:
l The lithium battery is used to back up the calendar
and other memory functions.
l The battery will last about one year of normal usage.
l Replace the battery with a new CR2025 cell when
the VIEWCAM’s time indicator starts to fall behind
the correct time.
B BATTERY MAY EXPLODE IF MIS-
USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS-
SEMBLE OR DISPOSE OF IN FIRE.
Removing the Lithium Battery from the
Ba ttery Holder
Place a pointed object such as
the tip of a ballpoint pen into the
small opening on the battery
holder and lift out the battery.
nstalling the Battery in the
qemote Control
1
2
3
Hold the remote control
facing down, then pull out the
battery holder while pressing
the tab toward the center.
Install the supplied CR2025 lithium battery
with its + side matching the @ marked
side of the battery holder.
Insert the holder in the direction of the
arrow. Make sure that the @ side faces the
back of the remote control.
Press here.