Programming instructions

Basic Components
Multisim Component Reference Guide 2-12 ni.com
• Resistance — the maximum resistance of the potentiometer.
•
Maximum Rated Power (Watts) — If this value is exceeded during simulation, the
potentiometer blows.
3. Click OK.
2.2.14 Rated Pullup
This component is used to raise the voltage of a circuit to which it is connected. One end is
connected to Vcc. The other end is connected to a point in a logic circuit that needs to be
raised to a voltage level closer to Vcc.
 To adjust the component’s tolerances:
1. Double-click on the placed component and click the Value tab.
2. Change the following values as desired:
•
Animation Delay Factor — increase this number to slow the speed of animation of the
symbol blowing. This is not a real-time value.
•
Vol t a g e ( V) — set as desired.
•
Resistance — set as desired.
•
Maximum Rated Power (Watts) — If this value is exceeded during simulation, the
pullup blows.
3. Click OK.
2.2.15 Rated Resistor
Resistors come in a variety of sizes, related to the power they can safely dissipate.
Note Refer to the Component Reference Guide for a more detailed discussion of resistors.
ComponentRef.book Page 12 Thursday, December 7, 2006 10:12 AM