Programming instructions

LCDs
 National Instruments Corporation 8-5 Multisim Component Reference Guide
8.2.2 Four Digit LCD Display
This feature is not available in all versions of Multisim.
This device is a four-digit LCD display.
8.2.3 Graphic LCD Display
This device emulates the behavior of a graphical LCD and controller. The controller is based
on the Toshiba T6963C controller.
Note For a demonstration of this part, refer to the Multisim MCU Module chapter of
Getting Started with NI Circuit Design Suite.
The following information is included in this section:
• Features
• Pin Descriptions
• Basic Commands
For more detailed information on the T6963C controller, including datasheets, National
Instruments recommends that you check the internet.
ComponentRef.book Page 5 Thursday, December 7, 2006 10:12 AM