Programming instructions

Current-Controlled Voltage Source
 National Instruments Corporation 1-9 Multisim Component Reference Guide
1.13 Current-Controlled Voltage Source
The output voltage of this source depends on the current through the input terminals. The two
are related by a parameter called transresistance (H), which is the ratio of the output voltage to
the input current. It can have any value from mW to kW.
1.14 Voltage-Controlled Current Source
The output current of this source depends on the voltage applied at the input terminals. The
two are related by a parameter called transconductance (G), which is the ratio of the output
current to the input voltage. It is measured in mhos (also known as seimens) and can have any
value from mmhos to kmhos.
1.15 Current-Controlled Current Source
The magnitude of the current output of a current-controlled current source depends on the
current through the input terminals. The two are related by a parameter called current gain (F),
H
V
I
OUT
IN
=
G
I
V
OUT
IN
=
ComponentRef.book Page 9 Thursday, December 7, 2006 10:12 AM