Service manual

36
VL-FD1U
VL-SD20U
2) Shifting to the normal operation mode
Set the data for the address "0000" to " FF".
]
This shifts the mode to the normal operation mode.
]
Press the "CONTINUE" key, and the "CAM ADJ" display goes out of the screen, enabling the normal operation.
(5) Camera unit adjustment procedure
2. Iris basic adjustment
1. Auto focus adjustment
6. Color gain coarse adjustment
7. White balance adjustment
8. Color gain adjustment
9. Auto white balance adjustment
10. White gain adjustment
3. Black balance adjustment/A/F noise adjustment
4. Iris AE adjustment
5. White balance coarse adjustment
* The above 1. Auto-focus function adjustment and 2. Iris basic adjustment are performed in the auto-focus function adjustment
mode, whereas the other adjustments are made in the camera signal system adjustment mode.
* After completing the auto-focus adjustment mode, set the camera signal system adjustment mode. (Take care that the adjustment
mode transfer address is different.)
(6) Replacement procedure of gyro unit
1) When replacing E
2
PROM: IC1001 of camera head with the gyro unit not replaced
Since the adjustment data of gyro is written in IC1001, copy the data of addresses "864, 865" and rewrite them after
replacement.
2) When replacing the gyro sensor: S1501
After replacing with the specified gyro sensor, write the following data in the addresses "864, 865".
S1501 Address Data
Replacement with RSNG0005CE01
0864 06
0865 FF