Manual

Cannot play back, rewind Position at beginning or end of tape. Rewind or fast forward tape to

fast forward tape. desired point (p.21).

Video noise in image. Dirty video heads. Call for service (p. 57).

Old or worn tape. Use a new cassette.

iiiiiiiiiiiiiii_

Cassette will not eject. Power source is not properly Connect power source properly

connected. (pp. 7, 9).

Battery pack is not charged. Charge battery pack sufficiently

/p8>

VIEWCAM is recording. Stop tape and try again (p. 18).

No image on monitor, aacklight has been turned off. Turn on backlight (p. 48).

Fluorescent lamp is burned out. Call for service (p. 57).

Monitor picture is hard to Inappropriate picture adjustments. Adjust picture (p. 47).

see.

CHARGE indicator AC adapter or battery pack may have Call for service (p. 57).

flasheScharg,nginbatteryredwhenpackmalfunctioned

Cannot edit to connected Audio/video cable is not properly Connect audio/video cable properly

VCR. connected. (p. 49).

Lens makes rattling Does not indicate a malfunction.

sound when VlEWCAM is

moved in VCR mode or

withpoweroff

Remote control does not REMOTE menu item is set to "OFF". Set REMOTE menu item to "ON"

function. (p. 39).

Remote control batteries have run Replace remote control batteries with

down. new ones (p. 39).

Remote control used beyond Use remote control within operating

operating range, range (p. 39).

Intense daylight falling on VlEWCAM Protect remote sensor from exposure

remote sensor, to intense daylight (p. 39).

Obstacle between remote control and Remove obstacle or use remote

VlEWCAM remote sensor, control from different angle (p. 39).

Notes:

• This unit is equipped with a microprocessor, its performance coukt be adversely affected by external electrical

noise or interference. If this should happen, turn off the power and disconnect the unit from any power sources,

including the lithium battery, etc. Then reconnect the power sources to resume operation.

• If the characters displayed on the monitor screen appear to malfunction, disconnect the power source and

remove the lithium battery, then reconnect the power source, insert the lithium battery, and turn the power on

again. The characters on the monitor should be normal. Set the date and time, then resume operation.