Manual

Precautions
• When the VIEWCAM is not in use,
remember to remove the cassette tape,
turn off the power, and disconnect the
VIEWCAM from the power source.
• Do not aim the lens at the sun.
Do not allow direct sunlight te strike tile
VIEWCAM lens or LCD monitor screen,
whether or not recording is in progress, as it
may damage tile CCD sensor or LCD screen
surface, Be particularly careful when
recording outside.
• When shooting in clark places, avoid sudden
brightly lit objects or light sources, such as
the sun. Otherwise, the image may white out,
Should this happen, point the lens in a
different direction until the pict_re returns to
normal.
• Avoid magnetic
sources.
Using tile VIEW('AM
near strong fluorescent
lights, motors,
televisions, or other
magnetic sources may adversely affect
recorded images.
• Using the VIEWCAM near a broadcasting
station or other powerful transmission
source may cause buzzing or picture
deterioration.
• Avoid shocks and
dropping,
Do not drop or otherwise
subject the VIEWCAM to hard
shocks or strong vibrations.
Bumping or striking the unit
during recording will
generate noise in tile
recorded image.
• Avoid placing the
VIEWCAM in close
proximity to lighting
equipment.
The heat from
incandescent lights
may deform tile
VIEWCAM, or cause it
to malfunction.
• Always respect prohibitions or restrictions
on the use of electronic equipment on
commercial flights or in other sensitive
areas.
• Be aware of the temperature and humidity.
You can use your VIEWCAM at 0°C to +40°0
(32°F to 104°F), and at 30% to 80% relative
humidity. Do not store the unit in an
unventilated car in tile
summer, in direct
heat sources; this can
result in severe d_lmage., I.-_F._x_ ._'..
to the unit casing and _"_;
circuitry.
• Avoid situations where water, sand, dust or
other foreign matter could get on or inside
the VIEWCAM, and do not use or leave
yourVIEWCAM in areas with excessive
smoke, steam or moisture.
Sllch environments can
cal_se maJ[l_nctJor/s or \TJ:,J
F\#MS;)
cause mildew to term --_:_i_',
on the lenses. Be sure J_ts,_.lr_._,.',,
to keep tile unit in a
well ventilated location.
• Some small, portable
tripods may be difficult to
attach and may not be
sturdy enough to support
your VIEWCAM. Be sure to
use only a strong, stable
tripod.
• When using your VIEWCAM in a cold
environment, the LCD monitor screen often
appears less bright immediately after the
power is turned on.This is not a
malfunction. To prevent the VIEWCAM from
becoming too cold, wrap it in a thick cloth
(a blanket, etc.).