Manual

Easy Camera Recording with
Full Auto Mode
Before you start recording, perform the operations
described on pages 7 through 17 to prept_re your
VIEWCAM for recording,
REC START/STOP button
1
2
LCD monitor screen
Power switch
Remove the lens cap (see page 17).
Hold down the Lock button and slide the
Power switch to CAMERA.
• _he picture from the lens is now
displayed on the LCD monitor screen,
• _t/e VIEWCAM is now ready to record
(Recording Standb_ mode).
Lock button
Full Auto mode indicator
Note: if, at this timer "AUTO' does not appear,
set the V)EV'_CAM to Full Auto mode by following
the procedure described on page 35
Press the REC START/STOP button to
begin recording.
_Ec e))>}>l
RE6
J
Note:
• When recordirlg at the beginning of a tape, advance
the tape abou_ 15 seconds before you begin
recording This will prevent the beginnff_g of the
recording being cut off when it is played back
To Pause Recording
Press [he REC START/STOP button again,
Recording pauses, and the VIEWCAM enters
the Recording Stanclby mode.
REC ! ! ..... I
PAUSE
I
I
N!..... ]
To Turn the Power Off
.Slide the Power switch to
OFF,
Notes:
• The speaker is off in Camera mode
• Battery power is consumed in Recording Standby
mode Turn off the power if you will not be recording
again sex)r],
• If the V]EWCAM is kept in Recording Standby mode
for more than approximate!y 5 minutes, the power
will automatically turn off to save battery power and
to protect the tape from being damaged To
continue recording after this, set the Power _;vvitch to
OFF, and then back to CAMERA
Maximum Continuous Recording and
Actual Recording Times
BT-H22
BSH32
a}prox approx,
1hr, 35 m n, 45 rain,
approx, approx,
3 hr 10 rain, 1 hr. 36 rain,
Note:
• Using the zoom (see page 19) and other functions
or turning the power on and off frequent)y wi)!
increase power consumption.This may result in a
decrease of more than 50% in the actual
recording time compared to the maximum
continuous recording time listed above.
i iii_
18