System information

Disk on Chip

28 – Reference VSBC-6 Reference Manual

OMPATIBLE

EVICES

Any 5 Volt, M-Systems series rev 1.10 or later 2000 DOC device will work.

NSTALLING THE

DOC C

HIP

1. Align pin 1 on the DOC with pin 1 of socket U22.

2. Push the DOC into the socket carefully until it is fully seated.

3. Make sure jumper V10[1-2] is installed.

Warning! The DOC can be permanently damaged if installed incorrectly! When installing

or removing the DOC, be sure to align the chip as shown in the picture below. To

prevent electrostatic damage, first touch a grounded surface to discharge any static

electricity from your body.

Figure 5. Disk On Chip Orientation

CMOS S

ETUP

To enable the DOC as drive C on a system without a hard disk, set the CMOS setup of drive C to

“not installed”, and reboot the computer.

Note! The DOC needs to be formatted with the System files in order for it to be a

bootable drive. Refer to the M-Systems web site (www.m-sys.com) for

documentation on the DOC and details on making it a bootable device.

U22

Pin #1