System information

DOS Installation
VSBC-6 Reference Manual Configuration / Operation – 13
DOS Installation (continued)
A:\NET\PROTOCOL.INI (continued)
[ms$netbeui]
drivername=netbeui$
SESSIONS=10
NCBS=12
BINDINGS=ms$ne2clone
LANABASE=0
A:\NET\SYSTEM.INI
[network]
filesharing=no
printsharing=no
autologon=yes
computername=COMPNAME
lanroot=A:\NET
username=
password=
workgroup=NETNAME
reconnect=no
directhost=no
dospophotkey=N
lmlogon=0
logondomain=NETNAME
preferredredir=full
autostart=full
maxconnections=8
[network drivers]
netcard=smc9000.dos
transport=ndishlp.sys,*netbeui
devdir=A:\NET
LoadRMDrivers=yes
[Password Lists]
*Shares=A:\NET\Shares.PWL
Creating a Bootable DOS DiskOnChip
The DiskOnChip is shipped pre-formatted, non-bootable, without any files on it. The
DiskOnChip will appear as Drive D in systems with an installed hard drive. If a hard drive is not
installed, the DOC will appear as Drive C:
1. Boot your system under DOS or Windows (if using Windows, start a DOS session)
2. Type SYS C: (or SYS D: if appropriate)