System information

Initial Configuration and Setup

6 – Configuration / Operation VSBC-6 Reference Manual

Initial Configuration and Setup

The following list describes the recommended components and gives an abbreviated outline for

setting up a typical development system.

ECOMMENDED

OMPONENTS

• VSBC-6 Single Board Computer

• 168-pin DIMM SDRAM Memory Module (PC-66 or PC-100) (VSBC-6 rev 4.00 or later)

• 168-pin DIMM EDO Memory Module (VSBC-6 Rev 2 or 3)

• ATX Power Supply

• SVGA Video Monitor

• Keyboard with PS2 connector

• 3.5" Floppy Disk Drive (optional)

• IDE Hard Drive (optional)

• IDE CD ROM Drive (optional)

DRAM M

ODULE

• Insert DRAM module into the DIMM socket. Latch into place.

ABLES

/ P

ERIPHERAL

EVICES

• Plug video adapter cable (p/n VL-CBL-1601) into socket J11 and attach video monitor.

• Plug keyboard adapter cable (p/n VL-CBL-1602) into socket J7 and attach keyboard.

• Plug floppy data cable (p/n VL-CBL-3403) into socket J18 and attach floppy drive.

Note! Floppy drive should be connected after the twist in the cable.

• Plug hard drive data cable (p/n VL-CBL-4001) into socket J17. Attach hard drive and

CD ROM drive to the connectors at the opposite end of the cable.

• Plug power supply into J4.

• Attach power supply cables to external drives.

• Jumper hard drive to operate as a master device.