System information

EPM-15 Reference Manual 8
Configuration and Setup
Initial Configuration
The following components are recommended for a typical development system.
 EPM-15 Computer
 ATX Power Supply
 SVGA Video Monitor
 Standard I/O Utility Cable (CBR-5010)
 USB Keyboard
 USB Floppy Disk Drive
 IDE Hard Drive (optional)
 IDE CD ROM Drive (optional)
The following VersaLogic cables are recommended.
 CBR-1201 – Video adapter cable
 CBR-5010 – Utility I/O cable (CBR-5009A) and breakout board (CBR-5010B)
 CBR-4406 – IDE data cable
 CBR-4405 – IDE adapter board, if you are using drives with 40-pin connectors
 CBR-1008 – Power adapter cable
You will also need a Windows (or other OS) installation CD.
Basic Setup
The following steps outline the procedure for setting up a typical development system. The EPM-
15 should be handled at an ESD workstation or while wearing a grounded antistatic wrist strap.
Before you begin, unpack the EPM-15 and accessories. Verify that you received all the items you
ordered. Inspect the system visually for any damaged that may have occurred in shipping.
Contact [e-mail] immediately if any items are damaged or missing.
Gather all the peripheral devices you plan to attach to the EPM-15 and their interface and power
cables.
It is recommended that you attach standoffs to the board (see Hardware Assembly) to stabilize the
board and m
ake it easier to work with.
Figure 3 shows a typical start-up configuration (using RoHS compatible cables).
22