Operation Manual

GB-10
BASIC OPERATION
IMMEDIATE RECORDING
SELECTION OF A CHANNEL
Select the channel by using the number buttons on the remote control, or select the
next/previous channel by pressing
CHANNEL [KorL].
To change between single digit and 2-digit channel numbers, press
AM/PM .
For example, for channel 24, press
AM/PM then press 2 4.
TAPE SPEED SELECTION
Your VCR has three tape speeds: SP (Standard
Play), LP (Long Play) and EP (Extended Play). Press
the
TAPE SPEED button on the remote control
to select the desired setting.
It is recommended that EP recordings are only
played back on the VCR on which they were
originally recorded.
You can record the channel you are watching or a different channel.
1. Insert a video tape into your VCR.
2. Select the channel you wish to record on the VCR.
3. To start recording, press REC ().
4. To pause during recording, press PAUSE/STILL (II).
5. To continue recording, press REC ().
6. To stop recording, press STOP (r) once.
SIMPLE TIMED RECORDING:
1. To specify a stop time, press REC ().
2. Each additional press of REC () will delay
the stop time by 10 minutes.
3. To stop recording at any time, press STOP (r)
once.
NOTES:
If the tape ends before the recording is complete the VCR will stop recording, rewind,
eject the tape and place the VCR into Standby mode, or just eject the tape and place
the VCR in Standby/timer mode if the VCR is in timer record mode.
If the VCR ejects the video tape when you press
REC () the tape is record protected.
i.e. record protection tab has been removed.
Cassette
Length
Recording
Time
E-240 In Minutes
SP 240
LP 480
EP 720
STOP 15:30