User Manual

45
If problems persist contact the SHARP Helpline on tel:[phone] (office hours)
or www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY SETTING THE CLOCK
The clock will normally be set using teletext information when your VCR automatically tunes in
the broadcast channels. If for any reason teletext signals are not present your VCR will not be
able to set the clock. This procedure will allow you to set the clock manually.
1. Press MENU. Press [ / ] to select SET UP.
Press SET to confirm.
2. Press [ / ] to select CLOCK. Press SET to
confirm.
3. Press [ / ] to select either 12 or 24 hour
clock.
4. Press [ / ] to select TIME. Enter the time
using the NUMBER BUTTONS or
[ / ]. If the minutes are less than 10, enter
the leading 0. If using the 12 hour clock enter
AM or PM by pressing on the remote
control.
5. Press [ / ] to select DATE. Enter the date
using the NUMBER BUTTONS or
[ / ]. For example, for 1st April enter
01 04.
6. Press [ / ] to select YEAR. Enter the last two
digits of the year using the NUMBER
BUTTONS or [ / ]. For example, for
2000 enter 00. For the year 2001 enter 01.
7. Select * for AUTO CLOCK on/off
(* is ON, - is OFF). Then press SET to confirm.
NOTE:
• If AUTO CLOCK is set to OFF (- is OFF) then you will need to update the clock for
daylight saving.
CLOCK
MODE T I ME DATE YEAR
24H 0:00 1/04 00 *
MODE : 24H / 12H
 : SELECT  : CHANGE
SET : ENTER MENU : EX I T