User Manual
40
CUSTOMISED INSTALLATION
INSTALLATION OF A SKY DIGIBOX RECEIVER
13. Press [ / ] to select MANUAL
TUNE.
14. Press SET to confirm
15. PRESET will be highlighted. Press
[ / ] to choose the required VCR
preset channel.
16. Press [ / ] to select SOURCE.
Then press [ / ] to select SAT.
17. Then press [ / ] to select
CHANNEL. Using the channel guide on
the following page enter the satellite
channel using the
NUMBER
BUTTONS.
18. Wait for the VCR to display ST*** next to
the Preset channel number (This will take
a few seconds), Press SET to confirm.
19. Repeat procedure from point 16 until all
desired satellite channels are stored in to
the VCR.
20. Press MENU to exit
21. Please return to HOW TO PLAYBACK
A VIDEO TAPE, at the front of the
manual.
IMPORTANT NOTE:
• If there is no response from your Sky Digibox, try adjusting its position to improve the Infra
Red VCR to satellite receiver reception.
MANU A L T U N I NG
SAT RECE I VER
SAT PROGRAM S EARCH
➔
PRESET ST1 0 6 1
SOURCE CH SAT
CHANNEL CH2 1
FINE TUNING
DECODER ON
OFF
SKIP ON OFF
▲
▲
MENU SET
CLEAR
PLUSCODE
If problems persist contact the SHARP Customer Helpline on tel: 08705-274277 (office hours)
or www.sharp.co.uk/support