User Manual

39
CUSTOMISED INSTALLATION
INSTALLATION OF A SKY DIGIBOX RECEIVER
SKY DIGIBOX INSTALLATION
5. Press MENU.
6. Press [ / ] to select SET UP. Press
SET to confirm.
7. CHANNEL PRESET will be highlighted.
Press SET to confirm.
8. Press [ / ] to select SAT RECEIVER.
Press SET to confirm. The satellite receiver
screen will appear.
If problems persist contact the SHARP Customer Helpline on tel: [phone] (office hours)
or www.sharp.co.uk/support
MANU A L T U N I NG
SAT RECE I VER
SAT PROGRAM S EARCH
Press [ / ], to set SAT CONTROL to
ON.
SAT RECE I VER
SAT CONTROL ON OFF
➔ INPUT RFIN L2
SAT NO. 001
PLEASE CONNECT-----
SAT L2 VCR
-----------
 : SELECT
 
: CHANGE
SET : ENTER MENU : EX I T
9.
VOLUME
INPUT
SELECT
CHANNEL
TV OPERATE
TIMER
ON/OFF
MODE OSD
DISPLAY
AUDIO OUTAM/PM
INPUT SELECT
123
45
78
6
9
10. Press [ / ], to select INPUT. L2 will
be highlighted.
If the VCR is not connected to the Digibox
as shown in CONNECTING THE
CABLES.
i. Your satellite receiver should be connected
to the Antenna (RF in on the back of the
VCR) select RF IN using [ / ] You will need
to tune the VCR into the Digibox.
ii. Press [ / ] to select CHANNEL.
Press [ ]. The current channel will be
displayed as a background to the on-screen
display. If this is not a satellite channel press
[ ] again. Continue until you see a satellite
channel.
11. Press [ / ] to select SAT NO. Using
the NUMBER BUTTONS enter 128.
12. When the arrows have moved from VCR to
SAT on the on screen display, press SET to
confirm.