User Manual

CUSTOMISED INSTALLATION

INSTALLATION OF A SKY DIGIBOX RECEIVER

1. Connect your Sky Digibox receiver to the VCR as shown in connecting the cables.

2. Place the receiver near the VCR (ideally on the top). This ensures that the reflected

infrared signals from the VCR which control the satellite receiver can reach it unimpeded.

3. Ensure the receiver is not in Standby or any special mode.

INSTALLATION PROCEDURE

Turn the TV on and select the video channel . (As previously explained)

NOTE:

• The preset Sky channels can now be tuned in as part of the installation procedure.

• If the AUTO INSTALLATION screen doesn’t

appear when you switch on your VCR or

you wish to reset your VCR and start the

installation again, refer to VCR RESET at

the back of the book.

Press STOP to switch on the VCR.

Step through the on screen instructions by

pressing the SET button.

If problems persist contact the SHARP Customer Helpline on tel: 08705-274277 (office hours)

or www.sharp.co.uk/support

See next page to continue

PLEASE BE SURE THE

AER I AL / SCART CABLE I S

CONNECTED TO YOUR VCR .

SET : ENTER MENU : EX I T

Press the SET button.

AUTO I NSTALLAT I ON

PRESS SET KEY TO START

SET : ENTER MENU : EX I T

SUPER P.SKIP SEARCH

MENU SET

CLEAR

PLUSCODE

3D-DNR/TBC