User Manual

36
If problems persist contact the SHARP Helpline on tel: [phone] (office hours)
or www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
The VCR has 99 programmable channel positions each of which can be set to any of the
broadcast and CATV channels shown in the table. If you select CC on the menu, cable will
be tuned first. Note that both cable and non-cable will be tuned regardless of the setting.
SATELLITE RECEIVER INSTALLATION
If you wish to connect a satellite receiver to your VCR after auto-installation without a satellite
receiver it is not necessary to completely re-install all channels. Follow the procedure below:
1. Press MENU.
2. Press [ / ] to select SET UP. Press
SET to confirm.
3. CHANNEL PRESET will be
highlighted. Press SET to confirm.
4. Press [ / ] to select SAT
RECEIVER. Press SET to confirm. The
satellite receiver screen will appear.
5. Follow points 10-15 in AUTO
INSTALLATION (satellite/cable box
control only).
6. Then press [ / ] to select SAT
PROG SEARCH. Press SET to confirm.
The satellite channels will be installed. (This
may take a few minutes).
7. Then press MENU.
MANU A L T U N I NG
SAT RECE I VER
SAT PROGRAM S EARCH
MANU A L T U N I NG
SAT RECE I VER
SAT PROGRAM S EARCH