User Manual

35
If problems persist contact the SHARP Helpline on tel:[phone] (office hours)
or www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
• It should not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
To manually tune in a channel follow the procedure below.
1. Press MENU.
2. Press the / menu select buttons
to select SET UP. Press SET to confirm.
3. CHANNEL PRESET will be
highlighted. Press SET.
4. Press / to select CHANNEL.
5. IMPORTANT NOTE:
Press to select CH or CC. This will
determine whether off air (CH) or cable
(CC) is tuned first. Note that both off air
and cable will be tuned regardless of the
setting.
6. Press / to start tuning in either
direction. Tuning will stop when a channel
is received. If it is not the desired channel,
press / to continue tuning.
7. Press / to select FINE
TUNING. Press and hold / until
the sharpest colour picture is obtained.
IMPORTANT NOTE:
8. If you connect an independent decoder,
you must press / to select
DECODER, then select / to turn
the decoder function ON.
9. Press / to select SKIP.
The SKIP function determines whether the
channel can be selected when using the
CHANNEL / instead of the
NUMBER BUTTONS.
10. Press / to select ON or OFF for
this option.
11. Press SET to confirm.
12. Press MENU to leave this function.
SET UP
CHANNEL PRESET
CHANNEL SORT
CLOCK
➔
PRESET 1
CHANNEL CH2 1
FINE TUNING
▲
▲
DECODER ON OFF
SKIP ON OFF
CABLE RECEPTION
Station
Signals VHF
Real
Channel
Numbers
A
B
C
D
E
F
G
H
J
01
02
03
04
05
06
07
08
09
MENU SET
CLEAR
PLUSCODE
TAPE SPEED SURROUNDREC
DIRECT TV REC