User Manual

23
If problems persist contact the SHARP Helpline on tel: [phone] (office hours)
or www.sharp.co.uk/support
ADVANCED OPERATION
AUDIO DUBBING
PLAYING BACK AN AUDIO DUBBED TAPE
• If you want to listen to the original and the new dubbed audio signal simultaneously, you will
need to set AUDIO MIX to ON.
• You can change the audio output by pressing the AUDIO OUT button on the remote
control. Refer to the table below.
1. Press MENU, to display the main menu
on the screen.
2. Press [ / to select MODE.
3. Press SET.
4. Press [ / ] to select AUDIO MIX.
5. Press [ / ] to select ON.
6. Press SET, to return to the menu screen.
7. Press MENU, to exit to the normal screen.
NOTES: .
AUDIO MIX AUDIO OUT MODE VCR DISPLAY RESULT
ON
Hi-Fi and Mono audio
Original Hi-Fi audio (L&R
channels) and dubbed audio
Original Hi-Fi audio (L channel)
plus dubbed audio
Original Hi-Fi audio (R channel)
plus dubbed audio
• Do not start audio dubbing until AUTO or MANUAL tracking has been completed as the
audio signal will not be recorded correctly.
• Because the audio signal is recorded onto the mono track any previous recording on
this track will be erased.
• If AUDIO MIX in the mode menu is set to OFF, no sound will be heard during audio
dubbing.
AUDIO MIX ON OF F
16: 9 AUT O OF F
POWERSAVE ON
OF F
▲▲
2/ 2
▲▲
▲▼ :SELECT :CHANGE
SET :ENTER MENU :EXIT
MODE MENU SCREEN
▲
▲
➞