User Manual

22
If problems persist contact the SHARP Helpline on tel: [phone] (office hours)
or www.sharp.co.uk/support
ADVANCED OPERATION
AUDIO DUBBING
RECORDING SOUND ON TO A VIDEO TAPE (AUDIO DUBBING)
This feature enables you to add narration or background music to a pre-recorded tape.
• The audio signal will be recorded on the mono track. The Hi-Fi track will remain
unchanged..
1. Connect the audio source to the AUDIO
IN L-R terminals on the front of the VCR as
shown above.
2. Insert the pre-recorded tape into the
VCR.
3. Press PLAY/X2 ( ) to view the
recording.
4. If you wish to listen to the original Hi-Fi
track while you are recording the new
dubbed audio track you will need to set
AUDIO MIX to ON in the mode menu.
5. Press PAUSE/STILL ( ) when you
reach the point on the tape where you
want audio dubbing to start.
6. Press A.DUB (A.DUB will be shown on
your TV)
NOTE: The input source will be
automatically changed to L3 (Front
phono jacks)
7. Press PAUSE/STILL ( ) , to start audio
dubbing.
8. Press STOP ( ) , to finish audio dubbing
(A.DUB will disappear from your TV)
+
Connect your
audio equipment
to AUDIO IN L-R
terminals on the
front of your VCR.
If a microphone is to be used,
connect it to your audio
equipment
AUDIO SOURCE
II A. DUB L3
SP