User Manual

GB-5
INSTALLING YOUR VCR
AUTO INSTALLATION
IMPORTANT NOTE: By pressing the STANDBY button, the VCR will toggle
between STANDBY and LOW POWER modes. The VCR display will not be
illuminated in low power mode.
Press STOP to switch on your VCR.
This model will automatically tune in the TV channels in your area, sort them into a standard
order and set the clock.
The screen opposite should be showing on your TV.
Follow the instructions from the screens.
(Auto sort will take a few minutes to complete)
On completion, the MOVE MENU will appear
showing the present channel order. Press
MENU to
exit.
If the clock is NOT automatically set, the clock
screen will appear., refer to MANUALLY
SETTING THE CLOCK. To check the clock has
been set correctly, press DISPLAY until the time
appears on the display.
If you wish to customise the channel order refer to
MANUALLY SORTING CHANNELS.
VCR RESET
1. Press STOP to switch on the VCR.
2.
Press and hold MENU and CHANNEL buttons together on the front of the VCR
for 10 seconds.
3. The AUTO INSTALLATION screen should now be showing on your TV.
4.
Follow the on-screen display to proceed with auto installation.
✔
All the programmes should now be correctly tuned in and the clock set.
Refer to the CUSTOMISED INSTALLATION chapter if
• Your VCR could not tune automatically - due to for example poor reception.
• You wish to re-arrange the channel order.
• You wish to change the time on the clock or if the VCR could not set the time.
• If the screen above does not
appear, follow the procedure
VCR RESET below.
INSTALLAT ION AUTO
SUIVEZ LES INSTRUCT IONS
APPUYEZ TOUCHE REG. POUR
DEPART.
REG : VAL I DER MENU:QUI T