User Manual

If problems persist contact the SHARP Helpline on tel: 0990-274277

VCR RESET

1. Press the STOP button on the front of the VCR.

2. Press and hold MENU and CHANNEL buttons together on the front of the

VCR for 10 seconds.

✔

VCR RESET IS NOW COMPLETE

Please continue with your previous procedure.

RF CHANNEL TUNING

If you have a preferred RF output channel this can be set manually (21-69) by following the

procedure below.

1. Press the STANDBY button.

Press and hold the MENU button on the VCR front panel for 3 seconds.

3. Wait for a flashing channel number to appear on the VCR display.

4. The channel number can now be changed by using the CHANNEL or

buttons.

5. Press the SET button to store.

6. Your TV will now require tuning to the new channel.

RF THROUGH ON/OFF:

If you wish to connect your VCR to the TV with only a scart lead, the RF Output on your VCR

can be turned OFF and ON by pressing the CLEAR button then the SET button

on the remote control at point 2 of the TUNING THE TV INTO THE VCR section of this

manual on page 5. This will help minimise interference.

STOP

CHANNEL

CLEAR

SET