User Manual

INSTALLING YOUR VCR

AUTO INSTALLATION

9. Press [ / ] to select SAT NO. Turn to the table at the end of this manual. Look for

the make of your satellite receiver and use the NUMBER BUTTONS to enter the first

code number listed. For example number 8 should be entered 0 0 8. Your satellite

should now change to preset channel 12.

10.

If your satellite receiver has changed to preset channel 12, press SET to confirm the VCR

will automatically install both satellite and terrestrial channels. (This may take a few

minutes).

11. The VCR will attempt to copy the TV preset list (NexTView compatible TV’s only). During

the copying process the display will show the TV presets that are being copied. If the VCR

is unable to copy the TV preset list the terrestrial and satellite channels will be

automatically installed. (Auto install may take a few minutes.) On completion the MOVE

menu will appear showing the preset channel order. Press

MENU to exit. If the clock is

not automatically set, the clock screen will appear, refer to MANUALLY SETTING

THE CLOCK. To check the clock has been set correctly, press DISPLAY until the time

appears on the display. If you wish to customise the channel order refer to MANUALLY

SORTING CHANNELS.

NOTES:

• If your satellite receiver has not changed to preset channel 12 enter the next code

number on the list. Continue until the receiver shows preset channel 12, then continue

from point 10.

• If your satellite receiver is not listed at the end of this manual or after entering all the

numbers listed for your receiver, the satellite receiver preset channel has still not changed

to 12, enter

0 0 1, and look to see if the satellite receiver has changed to preset channel

12. If it has, continue from point 10. If not, press to select 0 0 2 and re-check. Continue

until your receiver changes to preset 12, then continue from point 10.

• If there is still no response from your satellite receiver, try adjusting its position to improve

the Infra Red VCR to satellite receiver reception.

• Auto-installation will stop when the satellite receiver reaches preset channel 199, or when

all the 84 VCR preset channels have been used.

• The VCR will place all found terrestrial channels starting at preset 1, then all satellite

channels from the first available preset channel after the terrestrial channels.

All the programmes should now be correctly tuned in and the clock

set.

If you replace your satellite receiver, you will need to follow the complete auto-

installation procedure to tune your VCR to the satellite receiver. This is because your

new satellite receiver will not over-write the previous satellite channels in your VCR.

If you connect a satellite receiver to the VCR for the first time, after auto-installation, see

SATELLITE RECEIVER / CABLE BOX INSTALLATION.