User Manual

6
INSTALLING YOUR VCR
AUTO INSTALLATION
VCR RESET
1. Press STOP to switch on the VCR.
2. Press and hold MENU and
CHANNEL buttons together on the
front of the VCR for10 seconds.
3.
The AUTO INSTALLATION screen should
now be showing on your TV. Press SET to
confirm.
4.
Ensure your AERIAL/SCART cable is
connected to your VCR and then press
SET to confirm.
5. SAT CONTROL WILL BE HIGHLIGHTED.
• If you do have a satellite receiver
connected to the VCR continue from
point 6.
• If you do not have a satellite receiver
connected to the VCR leave SAT
CONTROL set to OFF and press SET.
The VCR will attempt to copy the TV preset list (NexTView compatible TV’s only). During the
copying process the display will show the TV presets that are being copied. If the VCR is
unable to copy the TV preset list the terrestrial channels will be automatically installed. (Auto
install may take a few minutes.) On completion the MOVE menu will appear showing the
preset channel order. Press
MENU to exit. If the clock is not automatically set, the clock
screen will appear, refer to MANUALLY SETTING THE CLOCK. To check the clock has
been set correctly, press DISPLAY until the time appears on the display. If you wish to
customise the channel order refer to
MANUALLY SORTING CHANNELS.
Points 6-11. (Satellite/Cable Box Control only)
6. Select Channel 1 on your satellite receiver.
7. Press [ / ], to set SAT CONTROL to ON.
8. Press [ / ], to select INPUT. L2 will be highlighted. If the VCR is not connected to the
satellite receiver as shown previously.
i. Your satellite receiver should be connected to the Antenna (RF in on the back of the VCR)
select RF IN using [ / ] You will need to tune the VCR into the Satellite receiver.
ii. Press [ / ] to select CHANNEL.
iii. Press [ ]. The current channel will be displayed as a background to the on-screen
display. If this is not a satellite channel press [ ] again. Continue until you see a satellite
channel.
SAT RECE I VER
SAT CONTROL ON OFF
➔ INPUT RFIN L2
SAT NO. 001
PLEASE CONNECT-----
SAT L2 VCR
-----------
 :SELECT
 
: CHANGE
SET : ENTER MENU: EX I T
5.