Specifications

VCR Display
When the DISPLAY button is pressed, the display changes in the following way. (However, tfie foliovi’ing IS the cas
when the clock time is set and displayed in the Q-hour system.)
Example:
Example:
[TAPE REMAINING/CHANNEL] .
[TAPE COUNTER/CHANNEL]
-Al
Example:
[PRESENT TIME/CHANNEL]
Example
[OPERATING MODEICHANNEL]
l During timer recording or Sample Recordtng Timer, the drsplay shows the recoru ftnist
the display changes In the following way (If the “a” Indicator on the VCR display IS IV
tne TIMER ON/OFF button and then turn on the power.)
Example:
[RECORD FINISH TIME]
Example:
[OPERATING MODE]
Example.
[COUNTER]
trme When t’ie DISPLAY b&or IS pressec
cancel the time: s:andSy moae by Dressin:
Example,
[PRESENT TIME1
Example.
[REMAINING TIME]
[NOTE ‘7
= 3tir1ng Simple Recording Timer recording. “a lights
Counter Clear
Make sure the counter is displayed. then press the CLEAR button on the remote
control “0 00 00” IS displayed
!NoTE)
l i% counter WI;: reset to “0.00 00’ when the :ape IS rewound completely.
ml
Tape Remaining Display
On Screen Display
[VCR Display]
*Select FULL or COUNTER display mode by
pressing the MODE OSD button on the remote
control.
[On Screen Display]
I
REM 1:05
o:oo.oo
I
l Press the DISPLAY button on the remote
control.
l This iun:tan accurately drsplays the tape remaining only for tapes recorded in
P4L mode (II does not accurately display the tape remainmg for tapes recorded
I
[OSDI
[KR Dlspiayj -
In NTSC 0; MESECAM modes.)
L
. When you mser: the iape and the VCR is rn the stop mode, the taoe remaining cannot be computed The followlng mdlca!o; IC shxlr M’W !?e tax walning has not yf
been computed or cannot be computed
l When you start recording or playback. the VCR will begin the computation. However, this may take some time.
When computation IS completed. tape remaining will be shown on the OSD and VCR display for 5 seconds.
l I! tne “REM mode IS selected with the MODE OSD or DISPLAY button and the VCR is in stop mode, the tape WI/’ a.zzar:zall:b ~2s’ fsrv,z 3’ rewmd for a fe,
seconds and then the VCR will begin computmg the amount of tape remaining.
l Dunng computa!lon. the REC button WIII not function. and pressing the STOP, PLAY/x 2, or other buttons will lnterrupi In? c~m?~:a!icr
l Setting the DPSS or ZERO-BACK function durtng computation may cancel it.
. The inaicared length of tape remaining IS only an approximate guide.
l This function may not properly work fo: video tapes other than E60. E90, El80 and E240.
l The lenoth of tape remalnin
l When rv’srsn and SVflS
z&l
during fast forward or rewind may be Indicated as greater than it actually IS.
tapes are used with a cassette adapter, the indication may not be correct.
Warning for the length of tape remaining
When the tape reaches the point where only about five minutes of recording time is left. the remaining
length of tape will be automatically displayed, as a warning.
i>
l No warnmg. however. WIII be shown during timer recording or Simple Recording Timer recording
32