FEATURES » Auto Power ON Function » Simple Recording Timer » Audible Sound for easy operation 12 function remote control » 4 digit electronic tape counter with memory POWER SUPPLY: The voltage supply of the VC-A100S is AC 220V 50Hz. CASSETTE TAPE: VC-A100S uses cassette tapes, PAL VIDEO SIGNALS. AT SR ACCESSORIES Be sure that the following accessories are all are missing, contact your Sharp dealer. clued with your VCR.
MOISTURE CONDENSATION. * Rapid temperature changes and storage or operation in extremely high humidity environments may cause “dew” fo condense inside the VCR cabinet. Dew can cause serious damage to your tapes and the video heads. * This VCR is equipped with a built-in heater to prevent and remove condensation inside the unit. It functions when the power cord is plugged in.
Disconnecting TV Cables Disconnect the antenna cable from the back of your TV set and connect it to your VCR. ™ back panel ® ANTENNA IN Connected to outdoor ar indoor antenna or cable Connecting Antenna Cables to VCR Connect the antenna cable together ANTENNA [N terminal of your VCR. ANTENNA N VCR rear Connecting VCR to TV Connect the supplied round coaxial cable to the RF QUT terminal of the VCR. Plug the other end into your TV’s ANTENNA IN terminal.
Your VCR can receive VHF 2 to 12, CATV, UHF 21 to 69. Your VCR has 16 preset TV channel positions, each of which can receive one channel at a time. The channel positions have been preset at the factory as shown below. Position Pres st TV Channel Position Preset TV Channel 1 VHF 2 9 UHF &7 2 VHF 4 10 UHF VHF VHF VHF UHF UHF the picture is not clear, or if you want a channel different from the one preset, reset the channels as follows.
RECORDING A TV PROGRAMMER —In' Cassette Erase Protection Videocassette has a removable tab ta prevent accidental surefire of recorded mate: Removing the tab prevents recording. To record on a video cassette with the tab removed, place adhesive tape over the tab opening. ERASURE PROTECTION TAB Cez e L Recording a TV Programmer © Turn on your TV and select the video channel. @ Select the channel you want with the CHANNEL UP or DOWN button.
@ Now the recording length appears on the display. Press the mm or button to select the recording length in hours. (Set to 1.) Press the SET button, © Press the (D or O button to select the recording length in minutes. (Set to 30,) Press the SET button. This completes the timer receding setup procedure for one TV programmer. I1f additional programmed are to be set, repeat steps @ through ©. @ The programming is now complete. The actual time will be displayed in 10 seconds.
USING YOUR VCR WITH A VIDEO CAMERA l REMOTE CONTROL | You can also use your VCR with a video camera. The connection diagram below is for guidelines only. Refer io the operation manual of the video camera for precise connection information. The Re mate Control lets you operate your VCR at a distance. Just aim the front of the Remote Control at the WIRELESS REMOTE window on your VCR and press the control buttons as you would on your VCR.
Sl (e Format: Video recording system: Video signal system: Playing time: Tape width: Tape speed Antenna: Re caption channels; AF output signal: Power requirement: Power consumption: Operating temperatures: Storage temperature: Video input: output: Audio input: output: Dimensions: Weight: Supplied accessories: Design and specifications VHS PAL standard Two rotary heads, helical scan PAL color or monochrome signals; 240 min. with E-240 video cassette 12.7 mm 2339 chemise.
