User`s manual

Chapter 3 Configuration
60
3.6.4 SNMP Setup
The SNMP Mode can be set to Enable so the MUXpro unit can be managed by
universal network management system (UNMS). If it is set to Disable, then the
UNMS will not see the MUXpro unit in the network.
This function allows user to set the “read community string” and “write read
community string” of SNMP. When system alarm occurs, user can set trap IP
where system alarm message will send to.
Figure 3-8 Manager List
3.6.5 DCC Setup
In this web page, user can set DCC（Data Communication Channels） IP and
channels of section.
Figure 3-9 DCC Setup