User`s manual

Chapter 3 Configuration
56
System Monitor User can check the parameters of connection, including
VCG status, Transmitted Trace ID and Expected Trace
ID of Section, VC-4 or VC12.
Fault Monitor User can check the current alarm event history and
alarm log.
Performance Monitor User can check the parameters of PM, such as CV, ES,
SES, and UAS.
Statistics User can check the statistics of LAN traffic or VCG traffic.
Diagnostics For diagnostics, user can use this function to Loopback
and verify the connection.
3.5 The Basic Concept in Configuring MUXpro
After entering the access level, user may follow the instructions below to become
familiar with MUXpro Series Product and be able to configure the units; therefore,
the units can work properly. This section will explain the basic concepts during
configuring MUXpro product.
3.5.1 System Clock
Define whether the system clock to be Internal or externally received from the
selected ports. Here you can also select the Primary and Secondary clock as the
system clock from the indicated port or optical line. If the port or line providing the
Primary clock fails, the alternative port for Secondary clock will become active as a
backup clock. For more information, please refer to 3.7.12
3.5.2 Cross Connection
Establish the internal communication link between SDH and either E1 or VCG.
This allows user to do the assignment for the indicated time slots. There are two
kinds of cross connection commands, e1xcset and vcgxcset. E1xcset is the E1
port (channel) assigned command, and is used to do the cross connection of E1
ports. Vcgxcset command is a usage for cross a connection to SDH (channel),
vcgxcm is used to execute multiple time slots cross connections. For more
information, please refer to 3.7.10