User Manual

Receiving a Phone Call
47
2. Cordless
Handset
Receiving a Phone Call
1 When the cordless handset rings, pick it up and press to answer.
Talk with the other party.
2 When you are ready to end the call, press .
• If the END CALL setting is set to “ON” (see page 63), you can also end the
call by simply placing the cordless handset in the cradle (or charger if you
have one). The call will end even if it has been placed on hold.
Putting a Call on Hold
To put the other party on hold during a call, press . While the call is on
hold, “C” will blink in the display. When you are ready to resume the call,
press once again.
♦ If the END CALL setting is set to “ON” (see page 63), placing the cordless
handset in the cradle (or charger if applicable) will end the call, even if the
call is on hold.
♦ If the END CALL setting is set to “OFF”, placing the cordless handset in the
cradle (or charger if applicable) will not break the connection while a call is
on hold, and thus phone charges may continue to apply.
You can also dial by entering the phone number first and then pressing .
♦ Check the number in the display before pressing . If there is a
mistake, press to clear the mistake and then enter the correct
digits.
Note: If a pause is needed between any of the digits to access an outside
line or a special service, hold down until “ ” appears.