Service manual

UX-A1000U
2 – 9
2 – 9
1 Reserved 0
2 End Buzzer Yes No 1
3 Disconnect the line when DIS is received in No Yes 1
RX mode
4 Equalizer freeze control (MODEM) On Off 0
5 Equalizer freeze control 7200 BPS only No Yes 0
6 CNG transmission in manual TX mode Yes No 1
7 Reserved 0
8 Modem speed automatic fallback when RX Yes No 0
level is under -40dBm
1 Recall interval Binary input 0
2 No. = 8 4 2 1 1
3 1 2 3 4 0
4 EX 0 1 0 1 eg. Recall interval is set to 5 min. 1
5 Recall times Binary input 0
6 No. = 8 4 2 1 0
7 5 6 7 8 1
8 EX 0 0 1 1 eg. Recall times is set to 3 times. 1
1 Dialing pause (sec/pause) 4 sec 2 sec 0
2 Dial tone detection (before auto dial) No Yes 1
3 Reserved 0
4 Busy tone detection (after auto dial) No Yes 0
Waiting time after dialing 45 seconds 55 seconds 90 seconds 140 seconds
5 No.5 0 0 1 1 0
6 No.6 0 1 0 1 0
7 Reserved 0
8 Reserved 0
1 Reserved 0
2 Reserved 0
3 Reserved 0
4 Reserved 0
5 Reserved 0
Auto dial mode delay timer of before line 0 second 1.5 seconds 3.0 seconds 4.5 seconds
6 connect No.6 0 0 1 1 0
7 No.7 0 1 0 1 0
8 Hold key Enable Disable 1
Auto dial mode delay timer of after line 1.7 seconds 3.0 seconds 3.6 seconds 4.0 seconds
1 connect No.1 0 0 1 1 0
2 No.2 0 1 0 1 0
3 Dial mode Tone Pulse 1 OPTION
4 Pulse → Tone change function by key Enable Disable 1
5 Dial pulse make/break ratio (%) 40/60 33/67 1
6 Reserved 0
7 Reserved 0
8 Recalling fixed only one time when dialing was Yes No 1
unsuccessful without detecting busy tone signal
1 DTMF signal transmission level (Low) Binary input 0
2 No. = 16 8 4 2 1 1
3 1 2 3 4 5 (nX0.5dBm) 0
4 EX 0 1 0 0 0 0
5 eg. Signal transmission level is set to –4dBm. 0
6 Reserved 0
7 Reserved 0
8 Reserved 0
SW
NO.
DATA
NO.
ITEM
Switch setting and function
1
0
Remarks
Initial
setting
SW
l
B5
SW
l
B4
SW
l
B3
SW
l
B2
SW
l
B1
SW
l
A6