User Manual

Messages and Signals
106
Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see Caller ID in Chapter 7 for
display messages related to Caller ID.
A.M. TRANSFER The answering machine's transfer function has been
turned on as explained in
Transfer Function in Chapter
2.
CHECK PAPER SIZE An incorrect size of paper has been loaded in the paper
tray. Remove the paper and load A4-size paper.
COVER OPEN The print compartment cover (under the operation panel)
is open. Open the operation panel (grasp the top and
pull toward you), and then press down firmly on both
sides of the print compartment cover to close it.
DOCUMENT JAMMED The original document is jammed. See the following
section,
Clearing Paper Jams.
FAX RX IN MEMORY A fax has been received in memory because the imaging
film needs replacement, you have run out of printing
paper, or the paper is jammed. After you fix the problem,
press the START/MEMORY key to print out the fax.
FILM END The imaging film may need replacement. Check the film
and replace if necessary.
FUNCTION MODE The FUNCTION key has been pressed.
LINE ERROR Transmission or reception was not successful. Press
STOP to clear the message, and then try again. If the
error persists, see
Line Error in Problems and Solutions
in this chapter.