Service manual
1 – 6
UX-385LU
3. Assembly and connections
Plug the power cord into a standard voltage, 60Hz, grounded AC
outlet.
• Caution: Do not plug the power cord into any other kind of outlet.
This will damage the machine and is not covered under the
warranty.
• The machine does not have a power on/off switch, so the power
is turned on and off by simply plugging in or unplugging the power
cord.
Note: If your area experiences a high incidence of lightning or power
surges, we recommend that you install surge protectors for
the power and telephone lines. Surge protectors can be
purchased at most telephone specialty stores.
Connect the handset as shown and place it on the handset rest.
♦ The ends of the handset cord are identical, so they will go into
either jack.
Insert one end of the telephone line cord into the jack on the back of
the machine marked TEL.LINE. Insert the other end into a standard
(RJ11C) single-line wall telephone jack.
Be sure to insert the telephone line cord into the TEL.LINE jack.
Do not insert into the TEL.SET jack.
Make sure the handset cord
goes into the jack marked
with a handset symbol on the
side of the machine!
Use the handset to make ordinary
phone calls, or to transmit and receive
documents manually.
TEL.
LINE
TEL.
SET
Attach the paper tray extension.
♦ Pull the paper release plate forward. Insert the paper tray exten-
sion horizontally into the notches in the paper tray. Rotate the pa-
per tray extension up until it snaps into place.
Attach the original document support.
Note: The original document support has a top side and a bottom
side. If you cannot insert the tabs on the support into the holes,
turn the support over.
4. Loading printing paper
You can load letter or legal size paper in the paper tray. The maximum
number of sheets depends on the weight and size of the paper you are
loading.
♦ Paper from 16 to 20 Ibs. (60 to 75 g/cm
2
):
Letter size: 60 sheets Legal size: 30 sheets
♦ Paper from 20 to 24 Ibs. (75 to 90 g/cm
2
):
Letter size: 50 sheets Legal size: 25 sheets
Note: If you are going to use letter size paper, remove the A4 paper
guide from the right side of the paper tray.
Fan the paper, and then tap the edge against a flat surface to even
the stack.