Service manual
1 – 1
UX-385LU
CHAPTER 1. GENERAL DESCRIPTION
[1] Specifications
Automatic dialing: Rapid Key Dialing: 5 numbers
Speed Dialing: 40 numbers
Imaging film: Initial starter roll (included with
machine): 32ft. (10 m) roll (approx. 30
letter-size pages)
Replacement roll:
UX-3CR 98ft. (30 m) roll (two rolls in
package, one roll yields approx. 100
letter-size pages)
Automatic document feeder: 10 sheets max. (20 Ib paper)
Memory size* : 512 KB (approx. 30 average pages with
ECM turned off)
Modem speed: 14,400 bps with automatic fallback to
lower speed
Transmission time* : Approx. 6 seconds (only when ECM is on)
Reception modes: FAX, TEL, TEL/FAX, TAD
Resolution: Horizontal:
203 pels/ineh (8 dots/mm)
Vertical:
Standard: 98 lines/inch (3.85 lines/mm)
Fine/Halftone: 196 lines/inch (7.7 lines/mm)
Super fine: 391 lines/inch (15.4 lines/mm)
Display: 16-digit LCD display
Recording system: Thermal transfer recording
Paper tray capacity: Letter: 60 sheets
(16-to 20-lb. paper) Legal: 30 sheets
Halftone (grayscale): 64 levels
Applicable telephone line: Public switched telephone network
Compatibility: ITU-T (CCITT) G3 mode
Compression scheme: MH, MR, MMR
Scanning method: Sheet-feeder CIS (Contact Image Sensor)
Effective printing width: 8.3" (210mm) max.
Input document size: Automatic feeding:
Width 5.8 to 8.5" (148 to 216 mm)
Length 5.5 to 11" (140 to 279 mm)
Manual feeding:
Width 5.8 to 8.5" (148 to 216 mm)
Length 5.5 to 23.6" (140 to 600 mm)
Effective scanning width: 8.3" (210 mm) max.
Contrast control: Automatic/Dark selectable
Copy function: Single/Multi-copy/Sort-copy
(99 copies/page)
Telephone function: Standard
(cannot be used if power fails)
Power requirements: Standard voltage, 60 Hz
Operating temperature: 41 to 95°F (5 to 35°C)
Humidity: Maximum: 85 %
Power consumption: Stand-by: 4.0 W
Maximum: 100 W
Dimensions: Width: 343 mm
Depth: 256 mm
Height: 182 mm
Weight: Approx. 3.4 kg
* Based on ITU-T (CCITT) Test Chart #1 at standard resolution in Sharp
special mode, excluding time for protocol signals (i.e., ITU-T phase C
time only).
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product
improvement without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some
deviation from these values in individual units.