Service manual

UX-385LU

3. 12. Entry data receive

In this mode, the registered data sent from the other machine is receiv-

ed and the received data is registered in the machine. When this mode

is used for receiving, the other machine must be in the entry data send

mode.

After receiving is completed, the following lists are printed.

1. Telephone list data

2. Sender register data (The passcode No. is also printed if the polling

function is provided.)

3. Optional setting list

4. Soft switch content

5. Junk fax number list

6. Timer reservation list (only model which timer communication is

possible)

7. Recording setting list data

2 – 4

Press

FUNCTION

9 8 7 START START

Press FUNCTION key.

Press key.

Bit1 - 8 are set.

Soft SW-A2 - SW-N3 are set.

S F T SW-A1 = 1 0 0 0 0 0 0 0

S F T SW-A2 = 0 0 0 0 0 0 0 0

S F T SW-N3 = 0 0 0 0 0 0 0 0

Press key during setting.

To finish the settings halfway between

SW-A1 and SW-N3, press the STOP

key. In this case, the setting being done

to the SW No. on display will be nullified

while settings done to the preceding

SW No. remain in effect.

The soft switch mode is terminated.

S F T SW-A1 = 0 0 0 0 0 0 0 0

START

DATA No. 1 2 3 4 5 6 7 8

When the COPY key is pressed, the

contents of soft switches are printed.

3. 13. Message print

In this mode, all the message data, which are used for diaplaying indica-

tion and list print, are printed as a contrast table of the selected lan-

guage and English.

4. How to make soft switch setting

To enter the soft switch mode, press the following key entries in se-

quence.